Now that we have released Axial’s newest scale shocks, which are officially licensed by Icon Vehicle Dynamics, I wanted to take some time to do a step by step build here on the blog to help people get the most out of their new shocks. These shocks are an improvement over our old SCX10 shocks, because of the new fully machined shock piston. The new piston provides a tighter fit inside the shock body which helps eliminate binds as the shock cycles through its travel. The new Icon shock bodies and reservoirs are clear anodized for durability and classic looks, which is a nice touch. Time to dig in and get our hands dirty!
Now we will fill the shock body about 3/4 of the way with shock oil and cycle the shock piston to dissipate any and all air bubbles. Make sure the piston stays submersed in the oil while you cycle the shock to get rid of the air bubbles. Once the bubbles are gone fill the shock body until the oil is about 1/16th of an inch from the top of the shock body, so just shy of being full. Once the shock shaft is fully compressed, you should see the oil crown just above the top of the shock body. Screw the cap down tight while holding the shock shaft fully compressed. Once the cap is tight, wipe any excess oil away. Cycle the shock shaft a few times and listen for air bubbles. If you can hear air bubbles gurgling around inside the shock, start over and use a little more oil. Make sure all air bubbles are gone before re-assembling. If the shock shaft won’t compress all the way after this step, you have a little too much oil in the shock body. Remove the shock cap, and re-bleed the shock with a little less oil.
That wraps up building Axial’s new fully licensed Icon shocks. Following these tips will help people get the most out of their new SCX10 shocks.